[Environment] menu
<< [Environment for display] >>
Changing the level of the geometry display. See [Environment for display] menu.
<< [Geometry Check] >>
CGVIEW can be used to help check geometry data for an EGS calculation. Input Start Position and Direction for particle. CGVIEW checks a geometry data at middle point of boundaries. if zones overlap, no define zone or outside zone's material number is not 0 then CGVIEW prints an error message.
Select [Environment]-[Geometry Check] in the main menu to open below Fig.
[Iteration]
Specifying number of particle (default=100000)
[StartPosition]
Specifying Start Popsition.(default value x= 0 - 0 y= 0 - 0 z= 0 - 0)
the range specification is enabled. In this case, a position is randamly selected in specified range.
[Direction]
Specifying Direction [degree].(default value theta= 0 - 360 phi= -90 - 90)
the range specification is enabled. In this case, a direction is randamly selected in specified range.
[CHECK START]
[Check Start] button to start check geometry data. [CHECK START]Button is [CHECK STOP] in executing and Click Button is Check Stop. If error then a message is printed in output and they are display by white lines.(error max is 10)
[CLOSE]
Close dialog, and return main.
[HELP]
Display of this help.